Add inspection to a permit/plan Navigate to your permit/plan you need to add an inspection to Go to the Workflow tab Find the inspection workflow Step Click the + button to add a new inspection Search for the inspection you want and check it off and click select Verify the priority and the sort order of the new inspection you just added. Make sure it falls into place where you need it to, if it does move on to step 10, if it needs to be moved proceed to step 7. For example in the image below the Final Gas cannot be done until the Planning inspection is done, and the Final CO and the Final Gas can be done at the same time becuase their numbers are the same. Becasuse the numbers are higher, they are not able to be done until the ones before it are complete. if you just need to add an inspection and you dont care when it needs to be done you can choose 0. Click the 3 lines on the left of the Workflow Steps area \ When the new page opens up find your new inspection and give it the number you need to. Click Complete Then you can save the permit record, by clicking the save button in the top right corner.